Other Useful Equipment for Resin Printing
These things can ease aspects of the resin printing process and make them more convenient
Syringe
- Any Syringe that is 50ml or larger would be great for adding or removing resin from a build vat
- I used a short (~1" or 25mm) piece of silicone rubber tubing attached to the syringe, makes a soft non-marring tip to prevent damaging the build surface
- When vat gets closer to empty, tilt the VAT and only touch the build surface in the corner with the rubber tube
Paint Filter
- Anytime resin is being poured back into its original bottle, it
mustMUST be filtered- This catches any pieces of cured resin that might have broken loose in the vat
- Better to filter every time resin is reclaimed than to break the LCD when a scrap gets in the wrong place
-
Disposable Paper paint filters
- Convenient because they are disposable, no cleaning filters
- Can be picked up at any Home Improvement or Paint store
- Would be an added operating cost, but ~$30USD for 1000 filters is quite affordable
- Larger mesh sizes (Lower mesh numbers) are faster for thick resins
-
Reusable Metal/Plastic mesh filters
- These are more of a pain, since they MUST be cleaned EVERY time!
- I chose a re-usable stainless steel coffee filter, but the ultrafine mesh makes filtering super slow!
- Now considering the move back to paper filters; I don't like washing dishes either...
Non-UV lighting
- Both Incandescent and Fluorescent lights produce small amounts of UV light and a 4 pack of these lights costs roughly the same as a bottle of resin... Bright lights everywhere!
- UV sensitive resin is not affected by White LED lights; they do not produce enough radiation in the UV spectrum
- I chose to install some cheap 4ft LED shop light fixtures from Amazon @ ~$10 each
